8 (7172) 57-63-46, 57-11-00, 56-11-99, 56-16-02, 8 (701) 924-78-80


Cisco Internetwork Expert Routing & Switching 2 (CIERS2)

Длительность

Дата проведения

Место проведения

Преподаватель

Подать заявку

Курс "Cisco Internetwork Expert Routing & Switching 2" (CIERS2)

Кому следует посетить

The primary audience for this course follows:
  • Network engineers that need be able to use an expert-level, problem-solving process including the Options Analysis method to support complex network technologies and topologies when both configuring and troubleshooting an internetwork
The secondary audience for this course follows:
  • Network designers that design and support complex network technologies and topologies

Сертификации

Этот курс является частью следующих программ сертификаций:
  • CCIE Routing & Switching (CCIERS Routing & Switching)

Предварительные требования

To gain the prerequisite skills and knowledge, learners must have passed the Cisco CCIE Routing and Switching written exam.
Before taking Cisco 360 CCIE R&S Advanced Workshop 2, learners should be very familiar with the topics that are covered in CIERS1. It is also strongly recommended that learners perform two self-paced, graded assessment exams before attending this course. Learners should be able to demonstrate advanced-level competencies (knowledge and skills) that are equivalent to the following from both configuration and troubleshooting perspectives:
  • Perform expert-level tasks involving WAN technologies and switched Ethernet networks
  • Perform expert-level tasks involving Routing Information Protocol version 2 (RIPv2), Enhanced Interior Gateway Routing Protocol (EIGRP), and Open Shortest Path First (OSPF)
  • Perform expert-level tasks for route redistribution
  • Perform expert-level tasks for Border Gateway Protocol (BGP)
  • Perform expert-level tasks for IPv4 multicast
  • Perform expert-level tasks for IPv6 unicast and multicast connectivity
  • Perform expert-level tasks for router quality of service (QoS) using the Modular QoS CLI (MQC)
Several training courses are available through Cisco Learning Partners that are recommended to meet the prerequisites:
Cisco CCNP
  • Implementing Cisco IP Routing (ROUTE)
  • Implementing Cisco IP Switched Networks (SWITCH)
  • Troubleshooting and Maintaining Cisco IP Networks (TSHOOT)
Beyond CCNP
  • Implementing Cisco Quality of Service (QOS)
  • Configuring BGP on Cisco Routers (BGP)
  • Deploying Cisco Service Provider Network Routing (SPROUTE)
  • Deploying Cisco Service Provider Advanced Network Routing (SPADVROUTE)

Цели курса

Upon completing this course, the learner will be able to meet these overall objectives:
  • Perform expert-level tasks involving both configuring and troubleshooting WAN technologies and switched Ethernet networks
  • Perform expert-level tasks involving both configuring and troubleshooting RIPv2, EIGRP, and OSPF
  • Perform expert-level tasks for both configuring and troubleshooting route redistribution
  • Perform expert-level tasks for both configuring and troubleshooting BGP
  • Perform expert-level tasks for both configuring and troubleshooting MPLS Layer 3 VPNs
  • Perform expert-level tasks for both configuring and troubleshooting IPv4 multicast
  • Perform expert-level tasks for both configuring and troubleshooting IPv6 unicast and multicast connectivity
  • Perform expert-level tasks for both configuring and troubleshooting router QoS using the MQC
  • Perform expert-level tasks for both configuring and troubleshooting Cisco Catalyst 3560 Series QoS
  • Perform expert-level tasks for both configuring and troubleshooting IP services